Does Reverse Osmosis Remove Nitrates?

DetoxWater Editorial Team•Published November 5, 2026

Yes, a properly installed and maintained reverse osmosis system can remove nitrates from drinking water by forcing water through a membrane that rejects dissolved nitrate ions. The amount removed depends on the system and your water, so look for a nitrate-specific performance claim and verify the treated water with a test. For a broader overview, see how to remove nitrates from water.

Does reverse osmosis make water with nitrates safe to drink?

Reverse osmosis can reduce nitrates, but installing a unit does not automatically mean the water meets the drinking water standard. The treated concentration matters more than the filter’s advertised percentage, especially when the source water contains a high level of nitrates.

The US Environmental Protection Agency’s maximum contaminant level for nitrates is 10 mg/L as nitrogen. This limit applies to regulated public water systems and is also a useful benchmark for testing private well water. Check that your lab report gives the result as nitrogen before comparing it with the limit; a result reported as nitrate is expressed on a different scale.

If your water is above the limit, use bottled water or another water supply known to be safe for drinking and preparing infant formula while you arrange treatment and testing. Infants are particularly vulnerable to the effects of excess nitrates. If an infant has blue or gray lips or skin, trouble breathing, or unusual drowsiness, seek emergency care immediately.

How does reverse osmosis remove nitrates?

A reverse osmosis unit uses water pressure to push water through a membrane. Some dissolved substances, including nitrate ions, are rejected by the membrane and carried away in a separate stream of concentrated water. The treated water is collected or delivered at the unit’s outlet.

The membrane is the critical component for nitrate reduction. A sediment filter or carbon filter included in a reverse osmosis system may protect the membrane or improve taste, but you should not assume those stages remove nitrates on their own. For the wider picture, read what reverse osmosis removes.

When shopping, check that the specific system model is independently certified under NSF/ANSI 58 for nitrate reduction. General reverse osmosis certification or a claim that a filter improves taste is not enough: look for nitrates in the certified performance information. Follow the manufacturer’s installation, maintenance and replacement instructions.

A typical under-sink unit treats water at its own dispensing tap, not necessarily at every faucet in the house. Use the treated-water tap for drinking and cooking, and make sure everyone preparing formula knows which tap to use.

What percentage of nitrates does reverse osmosis remove?

There is no single percentage you can assume for every reverse osmosis system, and no nitrate studies are available here to support a numerical removal rate. Actual performance can vary with the membrane, installation, water pressure, source-water composition and maintenance. Even a certified unit needs to be used within its specified conditions.

To find the reduction at your tap, have both the untreated source water and the treated water tested for nitrates. Use the same reporting units and basis for both results, then calculate:

Removal (%) = [(untreated concentration − treated concentration) ÷ untreated concentration] × 100

The calculation shows the reduction between those two samples; it is not a guarantee of future performance. Also compare the treated result with the applicable limit. A large percentage reduction may still leave too much nitrate in the water if the starting concentration is high.

Use a qualified drinking-water laboratory and follow its instructions for collecting samples. Test the treated water after installation and periodically thereafter, and follow the manufacturer’s recommendations after maintenance or membrane replacement. If your source is a private well, test the source water too: its nitrate concentration can change over time.

What can you use instead of reverse osmosis for nitrates?

If reverse osmosis is unsuitable, these options can provide water with lower nitrate levels:

OptionWhat to check
Nitrate-selective anion exchangeChoose a system designed for nitrate reduction, maintain it as directed and test the treated water. Its treatment material can become exhausted.
DistillationUse equipment intended for drinking water and verify its nitrate performance. Maintenance and correct operation matter.
Another water supplyUse bottled water or another source known to be safe while deciding on a treatment system or investigating the source of contamination.

An ordinary water softener is not the same as a nitrate-selective anion-exchange system. Likewise, do not rely on a basic carbon pitcher, sediment filter or ultraviolet light to remove nitrates unless the specific product has an appropriate nitrate-reduction claim.

Do not boil water to remove nitrates. Boiling does not remove them and can concentrate them as water evaporates. If a treated-water test remains above the limit, keep using a safe alternative and ask a water-treatment professional to check the system; retest before relying on it.

Frequently asked questions

Can I taste or smell nitrates in drinking water?

Nitrates cannot reliably be detected by taste, smell or appearance. A drinking-water test is needed to determine the concentration.

Does meeting the nitrate limit mean water is safe from every contaminant?

No. A nitrate result does not establish whether water meets standards for other contaminants. Consider other tests appropriate to your water source.