Is There Fluoride in Reno Water?
No fluoride is added to Reno water; the fluoride present is natural, with a measured mean of 0.24 mg/L in detected finished-water compliance samples from 2012–2019.
Does Reno water contain added fluoride?
Reno water contains naturally occurring fluoride, but it is not classified as fluoridated through an added fluoride product. Natural fluoride in a water source is not the same as adding fluoride to a community water supply.
The CDC’s 2025 fluoridation status report lists Truckee Meadows Water Authority, system ID NV0000190, as not fluoridated. For comparisons with other locations, see fluoride in tap water by city.
The status report and the measured concentration answer different questions: the report identifies the system’s fluoridation status, while testing measures how much fluoride is present. A “not fluoridated” status does not necessarily mean a fluoride concentration of zero.
How much fluoride is in Reno water?
The following results come from finished-water compliance samples collected from Truckee Meadows Water Authority during 2012–2019. They are historical measurements, not a guarantee of the concentration at a particular tap today.
| Measurement | Fluoride level | Year and basis |
|---|---|---|
| Mean of detected samples | 0.24 mg/L | 2012–2019; mean of detected finished-water compliance samples |
| Maximum | 0.29 mg/L | 2012–2019; highest result among finished-water compliance samples |
There were 125 finished-water samples in the dataset, with fluoride detected in 4. The 0.24 mg/L figure is the mean of the detected results, not necessarily the mean of all 125 samples. A non-detection does not establish that fluoride was absent; it means the test did not detect it at its applicable limit.
Both measured figures are below the following reference levels:
| Reference | Level | What it represents |
|---|---|---|
| US Public Health Service recommendation | 0.7 mg/L | Recommended level for community water fluoridation |
| EPA secondary standard | 2.0 mg/L | Non-enforceable secondary drinking-water standard |
| EPA maximum contaminant level | 4.0 mg/L | Enforceable federal drinking-water limit |
The 0.7 mg/L recommendation applies to community water fluoridation; it is not a requirement that a system with naturally occurring fluoride reach that level. Comparing a historical sample result with a standard also does not establish the current concentration at an individual tap.
How do Washoe County and Nevada compare?
The CDC’s state and county data report that 0.1% of the Washoe County public-water-system population received fluoridated water in 2020. The corresponding figure for Nevada was 76.4% in 2020.
Those percentages describe populations served by public water systems, not every resident or every water source. They provide geographic context; neither percentage determines the fluoridation status of Reno’s individual water system. The county and state figures are also from a different year than the 2025 system status report.
What is Nevada’s fluoride law or policy?
The data cited here do not establish Nevada’s current law or statewide policy on adding fluoride. The state and county percentages show reported coverage in 2020; they should not be read as a statement of what Nevada law requires.
For a current policy question, check Nevada’s applicable state and local requirements and ask your water supplier about its present practices. A statewide coverage figure alone cannot tell you what a particular supplier adds to its water.
How can you check your water or reduce fluoride?
Start by confirming which water system serves your address. Ask the supplier for its latest water-quality report and any recent fluoride results, noting the sampling date, concentration in mg/L and location or type of sample. If your water comes from another system or a private well, the Truckee Meadows Water Authority results may not describe it.
For a measurement at your own tap, use a test specifically designed for fluoride or ask a qualified water-testing laboratory to test a sample. Follow the laboratory’s collection instructions and ask how it reports results below its detection limit. A general total-dissolved-solids reading cannot identify the fluoride concentration. See how to test water quality at home for more on choosing a test.
If you want to reduce fluoride, look for a treatment system independently certified for fluoride reduction. Some reverse-osmosis systems and other specifically certified filters can reduce it, but not every filter or pitcher is designed to do so. Check the exact model’s certification and follow its maintenance and replacement instructions; our guide to the best pitcher water filters can help you compare options.
Boiling is not a fluoride-removal method: evaporation can leave the remaining water with a higher concentration. Testing before and after treatment can help you check the result for your own setup.
If you have questions about fluoride in your water, ask a dentist or doctor.
Where does the data come from?
The concentration figures come from the EPA’s Six-Year Review 4 compliance monitoring data for 2012–2019, using finished-water records for Truckee Meadows Water Authority. The mean summarizes detected results, and the maximum is the highest reported result in those records.
The CDC sources serve separate purposes: the 2025 status report identifies the system’s fluoridation status, while the 2020 state and county dataset gives public-water-system population percentages. Because the sources cover different periods and measures, they should not be treated as a single current tap-water test.
Frequently asked questions
What does mg/L mean on a fluoride report?
It means milligrams of fluoride per liter of water. It is a concentration, not the total amount a person consumes.
Does a non-detect mean there is no fluoride in the water?
Not necessarily. It means fluoride was not detected at the test’s applicable detection limit.
Does the historical mean describe every Reno tap?
No. It summarizes detected finished-water compliance samples from 2012–2019, rather than a current measurement at each tap.