Is There Fluoride in Omaha Water?

DetoxWater Editorial Team•Published November 5, 2026

Yes, Omaha’s Metropolitan Utilities District adds fluoride; the measured mean was 0.76 mg/L in detected finished-water compliance samples collected from 2012–2019.

The most recent utility status cited here is from 2025, while the measured concentration comes from older samples. For comparisons with other communities, see fluoride in tap water by city.

Is fluoride added to Omaha’s water?

Yes. The CDC’s 2025 fluoridation status report lists the Metropolitan Utilities District, Omaha’s water utility, as fluoridated. Its public water system identification number is NE3105507.

Fluoridation means fluoride is added to the water; it is distinct from fluoride occurring naturally in a water source. The reported status applies to the named utility, so check your water provider if you are unsure which system serves your address.

The 2025 status tells you whether the utility is listed as fluoridated. It does not give a current fluoride measurement at your tap.

How much fluoride was measured in Omaha’s water?

The EPA’s 2012–2019 compliance data show a mean of 0.76 mg/L among detected finished-water samples. There were 106 finished-water samples in the dataset, including 104 detections. The highest result among the 106 samples was 0.97 mg/L during that same period.

Measure or standardFluoride levelBasis
Omaha measured mean0.76 mg/LDetected finished-water samples, 2012–2019
Omaha measured maximum0.97 mg/LHighest of 106 finished-water samples, 2012–2019
U.S. Public Health Service recommendation0.7 mg/LRecommended level for community water fluoridation
EPA secondary standard2.0 mg/LSecondary drinking-water standard
EPA maximum contaminant level4.0 mg/LEnforceable federal drinking-water limit

The historical mean was 0.06 mg/L above the recommended level of 0.7 mg/L. Both the historical mean and maximum were below the 2.0 mg/L secondary standard and the 4.0 mg/L federal limit.

These numbers serve different purposes: the recommendation is not a maximum contaminant level, and the EPA secondary standard is not federally enforceable. The historical mean and maximum also do not establish the concentration in water at a particular address today.

How does Omaha compare with Douglas County and Nebraska?

In 2020, 99.4% of Douglas County’s public water system population received fluoridated water, according to CDC data. The corresponding figure for Nebraska was 73.8% of the state’s public water system population.

Those percentages describe populations served by public water systems, not every resident or every water source. In particular, they do not establish whether an individual private well contains fluoride or whether a particular address receives water from a fluoridated system.

The county and state figures are context rather than measurements of Omaha’s water. They come from 2020, while the utility’s listed fluoridation status is from 2025 and the measured samples are from 2012–2019.

What is Nebraska’s law or policy on fluoridation?

We found no verified information on a Nebraska-wide fluoridation policy in the sources cited here. The fact that Omaha’s utility is listed as fluoridated does not, by itself, establish what state law requires or permits.

Likewise, the 2020 statewide percentage does not describe a legal requirement. For a current explanation of applicable policy, contact Nebraska’s public health department or the Metropolitan Utilities District.

How can you check your water or remove fluoride?

Start by identifying your water provider. If the Metropolitan Utilities District serves your address, ask it for the latest drinking-water quality report and any more recent fluoride results. Check the date, the sampling location and whether a reported number is an average, a range or a single result before comparing it with the historical figures above.

For an address-specific result, consider a laboratory test for fluoride. Ask an accredited drinking-water laboratory about its collection instructions, the result units and how to interpret the report. Our guide to how to test water quality at home explains the broader testing process.

If you use a private well, a utility report or county percentage cannot tell you the fluoride concentration in your well. A test of your own water is the way to find out what it contains.

To reduce fluoride, look for a filter specifically certified for fluoride reduction, such as a suitable reverse-osmosis system or a pitcher with a certified fluoride-reduction claim. Check the exact model and replacement cartridge rather than assuming every filter of that type removes fluoride. Our guide to the best pitcher water filters can help you compare options, but verify the fluoride claim for the model you choose.

Follow the manufacturer’s installation and replacement instructions. Boiling does not remove fluoride and can concentrate it as water evaporates.

Who should ask about fluoride?

If you have questions about fluoride in your drinking water, ask a dentist or doctor. They can help you interpret the information for your circumstances.

Where does the information come from?

The CDC’s 2025 fluoridation status report identifies the Metropolitan Utilities District as fluoridated. It is the source for the utility’s listed status, not for the historical concentration figures.

The EPA’s Six-Year Review 4 compliance monitoring data contain the 2012–2019 finished-water samples used for the mean, maximum and sample counts. The CDC’s state and county fluoridation dataset supplies the 2020 Douglas County and Nebraska population percentages.

Frequently asked questions

What does mg/L mean?

It means milligrams per liter, a unit used to report the amount of a substance in water.

What is finished water?

Finished water is water that has completed treatment and is ready to enter the distribution system.

Does refrigerating water remove fluoride?

No. Refrigerating water does not filter out dissolved fluoride.