Is There Fluoride in Moreno Valley Water?
Yes, the utility adds fluoride; its 2025 water quality report lists a measured average of 0.7 mg/L.
Is fluoride added to Moreno Valley water?
Eastern Municipal Water District is listed as fluoridated in the CDC’s 2025 fluoridation status report. The CDC classifies the district as a consecutive system, meaning it receives water from another water system. That classification alone does not identify where fluoride is added.
Fluoride can also occur naturally in source water. Its presence in a water sample alone does not establish that a supplier added it; the fluoridation status and the measured concentration are separate pieces of information.
For comparisons with other locations, see fluoride in tap water by city.
How much fluoride is in Moreno Valley water?
The Eastern Municipal Water District 2025 Water Quality Report reports a measured fluoride average of 0.7 mg/L. That average matches the U.S. Public Health Service’s recommended level for community water fluoridation and is below both EPA standards shown here.
| Measure | Fluoride level | What it represents |
|---|---|---|
| Utility report | 0.7 mg/L | Measured average reported for 2025 |
| U.S. Public Health Service recommendation | 0.7 mg/L | Recommended level for community water fluoridation |
| EPA secondary standard | 2.0 mg/L | Non-enforceable secondary drinking-water standard |
| EPA maximum contaminant level | 4.0 mg/L | Enforceable primary drinking-water limit |
The utility’s reported average is not a guarantee that every sample or every tap will have the same concentration. The recommendation is a target for community water fluoridation, not a maximum limit.
How does Moreno Valley compare with Riverside County and California?
In 2020, 51.1% of Riverside County’s public water system population received fluoridated water. The corresponding figure for California was 57.5%, according to CDC state and county fluoridation data.
These percentages describe the public water system populations in the county and state, not the concentration of fluoride in Moreno Valley water. They also do not establish the fluoridation status of every individual address. The utility report is the more relevant source for the measured level associated with Eastern Municipal Water District.
What is California’s water fluoridation policy?
The cited sources do not establish California’s water fluoridation policy or whether any state requirements apply to Eastern Municipal Water District. The CDC’s consecutive-system classification describes how the system receives water; it does not by itself explain the district’s legal obligations or identify the point where fluoride is added.
For the policy and operating arrangements that apply to a particular service address, ask the water supplier or California’s drinking-water regulator. Keep the policy question separate from the utility’s measured fluoride average: a measurement describes what was reported in the water, not why a system has that status.
How can you check your water or remove fluoride?
Start by checking your water bill or contacting your supplier to confirm who serves your address. Request the latest water quality report and look for the fluoride entry, its measurement units and the period the report covers. If your supplier is not Eastern Municipal Water District, use your own supplier’s report rather than assuming the district’s average applies.
For a measurement at your tap, ask a laboratory whether it tests drinking water for fluoride and follow its sampling instructions. Request the result in mg/L so you can compare it with the report and standards above. Our guide to how to test water quality at home explains the process.
A utility-reported average and a sample from your tap answer different questions. Ask your supplier which report results are relevant to your address, and check the date and units on a laboratory result before comparing it with the 2025 average.
If you want to reduce fluoride, look for a filter independently certified for fluoride reduction. Reverse osmosis systems and some other treatment products can reduce fluoride, but not every pitcher or carbon filter is designed to do so. Check the specific model’s certification and follow its replacement schedule; our guide to the best pitcher water filters can help you compare options.
Who can answer personal questions?
If you have questions about fluoride in your drinking water, ask a dentist or doctor.
Where does the fluoride information come from?
The utility’s water quality report is the source for the measured 2025 fluoride average. The CDC status report identifies Eastern Municipal Water District as fluoridated and consecutive for 2025; it is a status source rather than the source of that measured average.
The separate CDC state and county dataset supplies the 2020 population percentages. Because those figures cover broader areas and a different year, they should not be substituted for a current utility report or a test of water at a particular tap.
To verify a reported number, find the fluoride entry and check both the units and the reporting year. A later utility report or a tap test may give a different value from the 2025 average.
Frequently asked questions
Is the reported 0.7 mg/L the same as 0.7 ppm?
For dilute water samples, the utility’s 2025 measured average of 0.7 mg/L is approximately 0.7 parts per million, or ppm.
Does boiling water remove fluoride?
No. Boiling is not a fluoride-removal method, and evaporation can leave a higher fluoride concentration in the remaining water.