Is There Fluoride in Jersey City Water?

DetoxWater Editorial Team•Published November 5, 2026

Yes, fluoride is present: the mean of detected finished-water compliance samples was about 0.08 mg/L in 2012–2019, but whether the utility adds fluoride is not reported.

Is fluoride added to Jersey City water?

The available measurement confirms that fluoride was detected in Jersey City’s finished water during the 2012–2019 reporting period. It does not establish whether the utility added fluoride or whether the detected fluoride came from another source.

Fluoride can occur naturally in water, but natural fluoride is not the same as community water fluoridation. A detection alone cannot establish the utility’s fluoridation status. For comparisons with other locations, see fluoride in tap water by city.

The measurement is historical, not a current reading from every Jersey City tap. Ask the water utility for its latest water quality report and whether it currently adds fluoride if you need an up-to-date answer.

How much fluoride was measured?

EPA’s compliance-monitoring dataset includes eight finished-water samples for Jersey City Municipal Utilities Authority, identified as NJ0906001, from 2012–2019. Fluoride was detected in three of those samples. The reported mean is based on the detected samples, not an average that treats all eight results as detections.

Measurement or referenceFluoride levelBasis
Jersey City detected-sample mean0.08 mg/LMean of detected finished-water compliance samples, 2012–2019
Jersey City maximum0.1 mg/LMaximum among finished-water compliance samples, 2012–2019
US Public Health Service recommended level0.7 mg/LRecommended level for community water fluoridation
EPA secondary standard2.0 mg/LNon-enforceable federal secondary standard
EPA maximum contaminant level4.0 mg/LEnforceable federal drinking-water limit

Both historical Jersey City measurements are below the three reference levels in the table. The 0.7 mg/L recommendation applies to community water fluoridation; it does not establish that Jersey City adds fluoride or that this was its target.

The two EPA standards serve different purposes: the secondary standard is non-enforceable federally, while the maximum contaminant level is an enforceable limit. Comparing a historical sample with those numbers is not, by itself, a determination of the utility’s current compliance.

What is the county and New Jersey context?

CDC data report that 16.1% of New Jersey’s public-water-system population received fluoridated water in 2020. That figure describes the state population served by public water systems, not the fluoride level in Jersey City or the status of every local system.

A Hudson County percentage is not reported in the available data. The state percentage also cannot establish whether Jersey City’s utility adds fluoride: individual systems can differ from the statewide picture.

What does New Jersey law say about fluoridation?

The available information does not establish New Jersey’s current fluoridation policy or whether a state law requires, permits or restricts fluoride addition. It also does not establish Jersey City’s current policy.

For a current policy answer, ask the utility and the relevant New Jersey drinking-water authority. Distinguish between a question about what state law allows and one about what the utility actually does; a state-level figure alone cannot answer the latter.

How can you check your water or remove fluoride?

Start with the utility’s latest consumer confidence report, often called an annual drinking water quality report. Ask the utility whether it adds fluoride, which system serves your address, and whether a more recent fluoride result is available. The historical EPA record identifies the system as Jersey City Municipal Utilities Authority, NJ0906001.

For a result from your own tap, ask a drinking-water laboratory whether it tests for fluoride and follow its sample-collection instructions. Check that the lab’s reporting range is suitable for the low concentrations you want to investigate. Our guide to how to test water quality at home explains how to approach testing.

If you want to reduce fluoride, look for a filter independently certified for fluoride reduction for the exact model and cartridge. A reverse-osmosis system certified to NSF/ANSI 58 for fluoride reduction is one option. Check the certification and replacement instructions rather than assuming that every filter removes fluoride; our guide to the best pitcher water filters is a place to compare pitcher options.

Who can answer questions about fluoride?

If you have questions about fluoride in your drinking water, ask a dentist or doctor.

Where does the data come from?

The EPA Six-Year Review 4 compliance-monitoring data provide the 2012–2019 finished-water sample results for Jersey City Municipal Utilities Authority. The CDC community water fluoridation dataset provides the 2020 New Jersey population figure. Neither source establishes whether the Jersey City utility currently adds fluoride.

Frequently asked questions

Does detecting fluoride prove it was added to water?

No. Fluoride can occur naturally, and a detection alone does not identify its source.

What does a nondetect mean in a water test?

A nondetect means the test did not report the substance above its reporting threshold. It does not necessarily mean the substance was completely absent.

Does boiling water remove fluoride?

No. Boiling does not remove fluoride and can concentrate it as water evaporates.