Is There Fluoride in Irving Water?
Yes, Irving’s utility adds fluoride, but a measured fluoride level is not reported.
For a broader comparison, see fluoride in tap water by city.
Does Irving add fluoride to its water?
Irving is listed as fluoridated in the CDC’s 2025 water-system status report. The report identifies the system as IRVING, with the public water system ID TX0570050. The fluoride product identified for the system is H2SiF6, also called fluorosilicic acid.
This is a report of added fluoride, not merely a finding that fluoride occurs naturally in the source water. The status identifies whether the system adds fluoride; it does not give the amount measured in Irving’s water. A later utility report is worth checking if you need the most current information.
How much fluoride is in Irving water?
A measured fluoride concentration for Irving is not reported in the available status information. That means the numbers below can provide context, but they cannot establish where Irving’s water falls in relation to any standard.
| Reference | Fluoride level | What it represents |
|---|---|---|
| Irving measured level | Not reported | No concentration, measurement year or measurement basis is available here |
| US Public Health Service recommendation | 0.7 mg/L | Recommended level for community water fluoridation |
| EPA secondary standard | 2.0 mg/L | A non-enforceable federal secondary standard |
| EPA maximum contaminant level | 4.0 mg/L | The federal enforceable limit for public drinking water systems |
The 0.7 mg/L recommendation is not a measurement of Irving’s water. Likewise, the 2.0 mg/L and 4.0 mg/L standards are comparison points, not reported results for the city.
If you obtain a utility result, check its year and whether it is an average, a range or another type of reported value before comparing it with these figures. A result from an individual tap is also a different kind of measurement from a system-wide report.
How does Irving fit into Dallas County and Texas?
In 2020, the CDC reported that 98.9% of the Dallas County population served by public water systems received fluoridated water. For Texas, the corresponding figure was 71.0% of the population served by public water systems in 2020.
These percentages describe coverage, not fluoride concentrations. They are not percentages of all residents regardless of water source, and the Dallas County figure is not an Irving-only measurement. Neither percentage establishes the fluoride level at a particular address.
The county and state figures also come from an earlier year than Irving’s 2025 status report. They are useful for geographic context, but should not be treated as an update to the city’s status.
What is Texas law or policy on fluoride?
The cited CDC reports do not establish Texas law or statewide policy on adding fluoride. Irving’s reported practice alone does not show that state law requires every Texas utility to fluoridate its water.
For a current answer about the rules governing Irving’s system, ask the utility or the Texas Commission on Environmental Quality. Keep the legal question separate from the status report: a utility’s reported practice and the law governing that practice are not the same piece of information.
How can you check your water or reduce fluoride?
Start by confirming which public water system serves your address. If it is Irving, ask the utility for its latest drinking water quality report and the fluoride result, including the sampling year and whether the figure is an average or another measure.
For a result specific to your tap, use a laboratory that offers fluoride testing and follow its sampling instructions. Our guide to how to test water quality at home explains how to approach testing. A home test or lab result should identify fluoride specifically; a general water-quality reading does not tell you its concentration.
If you want to reduce fluoride, look for a filter or treatment system independently certified for fluoride reduction. Reverse osmosis systems and distillers can reduce fluoride when designed for that purpose; some pitchers can reduce it too. Do not assume that every carbon filter or pitcher removes fluoride.
Check the certification and fluoride-reduction claim for the exact model and replacement cartridge, and follow the manufacturer’s maintenance schedule. See our guide to the best pitcher water filters when comparing pitcher options. If you want to know how well your own device is working, consider testing water before and after treatment.
If you have questions about fluoride in your drinking water, ask a dentist or doctor.
Where does the information come from?
The CDC’s 2025 fluoridation status report lists IRVING, TX0570050, as fluoridated. It is the source for the reported system status, not a substitute for a measured concentration in a utility water quality report.
The CDC’s state and county fluoridation dataset supplies the 2020 Dallas County and Texas coverage figures. The comparison values are the US Public Health Service recommendation and EPA drinking water standards; none is an Irving test result.
Frequently asked questions
Does boiling Irving water remove fluoride?
No. Boiling is not a reliable way to remove fluoride and can concentrate it as water evaporates.
Can you taste fluoride in drinking water?
Taste is not a reliable way to determine whether water contains fluoride or how much it contains. Use a fluoride-specific test or consult a water quality report.
What does mg/L mean on a fluoride report?
It means milligrams per liter, a measure of the concentration of fluoride in water.