Is There Fluoride in Arlington Water?

DetoxWater Editorial Team•Published November 5, 2026

Yes, Arlington, Texas, adds fluoride to its water; its measured mean was 0.48 mg/L in 2012–2019.

The historical measurement is not a current tap reading. For comparisons with other communities, see fluoride in tap water by city.

Does Arlington add fluoride to its water?

Yes. The CDC’s 2025 fluoridation status report lists the City of Arlington water system, TX2200001, as fluoridated. The fluoride product identified for Arlington is fluorosilicic acid, H₂SiF₆.

Fluoridation means fluoride is added to the water supply. Fluoride can also occur naturally in water, but its natural presence alone is not evidence that a utility adds it. Arlington’s reported status is that the utility adds fluoride.

How much fluoride is in Arlington water?

The available measurement is an older result from EPA compliance monitoring data for 2012–2019. It is an unweighted mean of detected finished-water samples across entry points, not a measurement taken at a particular home.

Measure or benchmarkFluoride levelWhat it represents
Arlington measured mean, 2012–20190.48 mg/LUnweighted mean of detected finished-water compliance samples
Arlington measured maximum, 2012–20190.8 mg/LHighest of the finished-water samples
US Public Health Service recommendation0.7 mg/LRecommended level for community water fluoridation
EPA secondary standard2.0 mg/LA non-enforceable secondary standard
EPA maximum contaminant level4.0 mg/LThe enforceable federal limit

All 16 Arlington finished-water samples in the 2012–2019 dataset detected fluoride. The mean was below the 0.7 mg/L recommendation, while the maximum was above it; both were below the EPA standards shown. The recommendation is a target, not the federal maximum contaminant level.

The older samples may include unfluoridated sources or predate current practices. They should not be used to assume the fluoride concentration at an Arlington tap today.

How does Arlington compare with Tarrant County and Texas?

In 2020, the CDC’s county and state fluoridation data reported that 97.7% of the public-water-system population in Tarrant County received fluoridated water. The corresponding figure for Texas was 71.0% in 2020.

These are population percentages, not measurements of fluoride concentration. They provide context for the county and state; they do not replace the City of Arlington’s system status or a test of a particular water source.

What is Texas’s law or policy on fluoridation?

The records cited here do not establish a Texas statewide fluoridation requirement or policy. Arlington’s reported fluoridation status on its own does not show whether fluoridation is required statewide.

For a current answer about state requirements or Arlington’s local decisions, ask the water utility or the Texas Commission on Environmental Quality. Keep the legal question separate from the measured concentration: a policy describes what is required or permitted, while a sample reports what was found in water at a particular time.

How can you check your water or remove fluoride?

Start with Arlington’s most recent drinking-water quality report, also called a consumer confidence report. Check the reporting year, the fluoride result and the units, and ask the utility if you need a current result or information about the source serving your address.

If your property uses a private well or another water supplier, Arlington’s utility report may not describe your water. A laboratory that tests drinking water for fluoride can measure your sample; ask for its sampling instructions and a result in mg/L. Our guide explains how to test water quality at home.

If you want to reduce fluoride, some reverse osmosis systems, distillers and activated alumina filters can do so. Check the specific model’s independent certification or performance information for fluoride reduction; not every filter or pitcher is designed to remove it. Compare options in our guide to the best pitcher water filters, and follow the manufacturer’s replacement instructions.

When to ask a professional

If you have questions about fluoride in your drinking water, ask a dentist or doctor.

Where does the data come from?

The CDC’s 2025 status report identifies the Arlington system and says it is fluoridated. The CDC’s 2020 county and state dataset describes the percentage of people served by public water systems who received fluoridated water in those areas.

The EPA’s Six-Year Review 4 dataset supplies the older Arlington finished-water sample results from 2012–2019. Its mean is calculated across detected entry-point samples without weighting them by the amount of water supplied. These sources answer different questions: utility status, population coverage and historical measured concentration.

Frequently asked questions

Is the 0.48 mg/L figure a current Arlington tap reading?

No. It is an unweighted mean of detected finished-water compliance samples collected in 2012–2019.

Does the Tarrant County percentage mean every resident received fluoridated water?

No. The 2020 figure describes the percentage of the county’s public-water-system population receiving fluoridated water, not every resident.

Will any water-filter pitcher remove fluoride?

No. Check the specific pitcher’s independent certification or performance information for a fluoride-reduction claim.