Is There Fluoride in Allentown Water?
Yes, the utility adds fluoride; its 2012–2019 finished-water compliance samples had an unweighted mean of 0.44 mg/L. For comparisons with other communities, see fluoride in tap water by city.
Does Allentown add fluoride to its water?
Yes. The CDC’s My Water’s Fluoride system list identifies ALLENTOWN CITY BUREAU OF WATER, system PA3390024, as fluoridated. The list does not show a data year for that status; it was retrieved on November 3, 2026.
Fluoride can also occur naturally in water, but naturally occurring fluoride alone is not the same as adding fluoride. The CDC listing identifies Allentown’s system as fluoridated, rather than indicating only that fluoride was detected.
How much fluoride has been measured in Allentown water?
The available measurement is an older average, not a current reading from a household tap. The table compares it and the highest sample result with three federal reference levels.
| Fluoride level | What it represents |
|---|---|
| 0.44 mg/L | Unweighted mean of 16 detected finished-water compliance samples at entry points, 2012–2019 |
| 0.6 mg/L | Maximum of those 16 detected finished-water compliance samples, 2012–2019 |
| 0.7 mg/L | US Public Health Service recommended level for community water fluoridation |
| 2.0 mg/L | EPA secondary standard |
| 4.0 mg/L | EPA maximum contaminant level |
The 0.44 mg/L mean and the 0.6 mg/L maximum were both below the 0.7 mg/L recommended level and the two EPA standards. The recommended fluoridation level is not the same as EPA’s enforceable maximum contaminant level; the secondary standard is a separate, generally non-enforceable federal standard.
The older sample average may include unfluoridated sources or predate current practice. It should not be used as a precise estimate of the fluoride level at your tap today.
How does Allentown compare with its county and Pennsylvania?
Allentown is in Lehigh County, but a countywide percentage of residents receiving fluoridated water is not available here. The Allentown system’s status should not be used to assume the status of every other water system in the county.
For Pennsylvania, CDC state and county fluoridation data report that 60.0% of the population served by public water systems received fluoridated water in 2020. That figure describes the state’s public-water-system population, not necessarily all Pennsylvania residents or every community.
Does Pennsylvania law require water fluoridation?
The available information does not establish whether Pennsylvania requires or prohibits community water fluoridation. The statewide percentage and Allentown’s reported status do not, by themselves, establish a state mandate.
For a question about current law or a particular system’s policy, check with the relevant Pennsylvania drinking-water authority or the water supplier. A supplier’s own report can also help identify the treatment practices used for its service area.
How can you check your water or reduce fluoride?
First, check your water bill or contact your supplier to confirm which system serves your address. Ask for its most recent consumer confidence report and a recent fluoride result; the historical Allentown data use system ID PA3390024.
To measure water at your own tap, ask a certified laboratory about a fluoride test and follow its sample-collection instructions. Request the result in mg/L so you can compare it with the levels above. A tap test describes the water collected at that time, while the historical EPA results describe finished-water samples taken at system entry points. For a broader testing guide, see how to test water quality at home.
If you want to reduce fluoride, look for a reverse-osmosis unit or another filter specifically certified for fluoride reduction. Not every pitcher or carbon filter is certified to reduce it, so check the certification and the exact replacement cartridge before buying. Our guide to the best pitcher water filters can help you compare options.
Follow the manufacturer’s installation and replacement instructions, and consider testing the treated water to check the result. Boiling is not a fluoride-removal method and can concentrate dissolved minerals as water evaporates.
Who should ask for advice?
If you have questions about fluoride in your drinking water, ask a dentist or doctor.
Where do the Allentown data come from?
The status comes from the CDC system list, while the historical measurements come from the EPA Six-Year Review 4 compliance monitoring data. In the EPA data, the system appears as LCA ALLENTOWN DIVISION with the same system ID, PA3390024.
The EPA dataset contains 16 finished-water fluoride samples for that system over 2012–2019, and all 16 detected fluoride. The mean shown above gives each sample equal weight; it is not a continuous measurement or a current household result.
Frequently asked questions
Does the CDC list give a year for Allentown’s fluoridation status?
No. The CDC system list identifies Allentown as fluoridated but does not show a data year for that status.
Does the historical average show what is in my tap water today?
No. The 0.44 mg/L average summarizes finished-water samples from 2012–2019; a recent report or tap test is needed to check a more current level.
Does the 2012–2019 range mean samples were taken every year?
Not necessarily. The date range alone does not establish that samples were collected in every year.