Is Tap Water Safe to Drink in Lexington?
Yes, Kentucky-American Water CO had no health-based drinking water violations reported in the last 3 years.
What does the EPA record say about Lexington’s tap water?
The EPA record supports that verdict for the utility’s water, but it does not guarantee the quality of water at every household tap. Lead and other problems can arise in a home’s plumbing, and the record is a snapshot rather than a substitute for current utility notices.
For a broader comparison, see tap water safety by state. Check Kentucky-American Water CO’s current notices and annual water quality report for the latest local information.
Who supplies Lexington’s water, and where does it come from?
Kentucky-American Water CO is the main water system listed for Lexington, Kentucky. EPA identifies it as a privately owned system that uses surface water.
The system’s reported population served is 669,042 people. That figure describes the water system’s service population, not just the population of Lexington itself. If you are unsure which utility serves your address, check your water bill or contact the utility.
What violations did EPA report in the last 3 years?
The following summary reflects EPA’s drinking water record retrieved on November 3, 2026. “Open violations” means violations currently reported in that record; it does not predict future results.
| Water system | People served | Health-based violations in the last 3 years | Open violations | Lead action-level exceedances in the last 3 years |
|---|---|---|---|---|
| Kentucky-American Water CO | 669,042 | None reported | None reported | None reported |
EPA reports no quarters with violations among the last 12 quarters. Its compliance history also marks a quarter as undetermined, so the record should not be read as a guarantee that every reporting period is final.
No lead action-level exceedance was reported for the system in that period. That is not the same as a lead test at your own tap.
What did PFAS testing find?
PFAS are a group of chemicals often called “forever chemicals.” In EPA’s UCMR 5 national survey, Kentucky-American Water CO’s samples were collected from March 6 through December 5, 2023. The results describe that sampling period, not necessarily current water at a particular address.
| PFAS result | Findings | Comparison or context |
|---|---|---|
| PFOA | Not detected in 16 samples | Reporting limit: 4.0 parts per trillion (ppt); EPA limit: 4.0 ppt |
| PFOS | Not detected in 16 samples | Reporting limit: 4.0 ppt; EPA limit: 4.0 ppt |
| PFBS | Detected in 2 of 16 samples; maximum 3.6 ppt | Reporting limit: 3.0 ppt |
| “Any other PFAS” grouping | Detected in 7 of 368 reported samples; maximum 11.1 ppt | A grouped result, not a result for one named chemical |
“Not detected” means a result was below the reporting limit, not necessarily that the chemical was absent. There was no detected PFOA or PFOS maximum to compare with their respective 4.0 ppt limits. The grouped “any other PFAS” maximum should not be treated as a PFOA or PFOS result.
EPA has set limits of 4.0 ppt each for PFOA and PFOS. Comparing survey results with those limits provides context, but compliance is based on running annual averages, not a single sample or maximum.
Could lead come from household plumbing?
Even when a utility has no reported lead action-level exceedance, water can pick up lead from service lines, solder or plumbing fixtures. A system-wide result cannot establish whether an individual home has lead in its water.
EPA’s lead health goal is zero. Its action level is 15 parts per billion (ppb), or 0.015 milligrams per liter; this is a system-wide trigger for action, not a guarantee that water from an individual tap is lead-free.
Who should be careful?
Children and pregnant people are particularly vulnerable to lead exposure. If you are concerned about possible exposure, use water from a source tested for lead or a filter certified to reduce lead, and discuss the concern with a doctor. Contact your local health department for help interpreting a test result.
Can you use the water for ice, brushing teeth and washing produce?
The EPA record does not show a health-based violation for the utility in the last 3 years. Still, follow any current utility notice about drinking water, making ice, brushing teeth or preparing food; an advisory may give specific instructions for those activities.
If you are concerned about lead from household plumbing, use cold water for drinking, cooking, making ice and washing produce. Boiling does not remove lead or PFAS, so it is not a substitute for a filter certified for those contaminants.
How can you get extra protection?
A household water test can answer questions that a system-wide record cannot. Use a laboratory that tests drinking water for the contaminant you are concerned about, and follow its sampling instructions. Our guide explains how to test water quality at home.
If you choose a filter, check its certification and product documentation for the specific contaminant you want to reduce. A filter certified for taste and odor is not automatically certified for lead, PFOA or PFOS. Replace cartridges according to the manufacturer’s instructions; see our guide to the best pitcher water filters.
Where does this information come from?
The violation and system information comes from the EPA ECHO detailed facility report for Kentucky-American Water CO, retrieved on November 3, 2026. The report uses EPA Safe Drinking Water Information System data.
The PFAS findings come from EPA’s UCMR 5 occurrence data, in a file dated October 15, 2026. For current operating details and any new notices, consult Kentucky-American Water CO’s latest annual water quality report and utility notices.
Frequently asked questions
What does a part per trillion mean in a water test?
A part per trillion, abbreviated ppt, describes a very small concentration. In water, 1 ppt is approximately 1 nanogram per liter.
Were PFHxS or PFNA detected in Lexington’s UCMR 5 samples?
Neither was detected in 16 samples for each chemical. The reporting limits were 3.0 ppt for PFHxS and 4.0 ppt for PFNA; a non-detect does not prove the concentration was zero.