Does Boiling Water Remove Pesticides?
No, boiling water does not reliably remove pesticides because water can evaporate without consistently removing or destroying the chemicals.
Can boiling make water with pesticides safe to drink?
Boiling is not a dependable treatment for pesticide-contaminated drinking water. As water turns to steam, pesticides that remain in the pot can become more concentrated in the water left behind.
We found no studies measuring pesticide removal by boiling drinking water, so research does not support a removal percentage. If pesticides are a concern, see how to remove pesticides from water for treatment options, and test the water for the specific chemicals involved.
Boiling can kill many disease-causing microorganisms, but killing microorganisms and removing chemicals are different jobs. For that distinction, see what boiling water removes.
How does boiling affect pesticides in water?
Boiling heats water until it turns to vapor. In an ordinary pot or kettle, that vapor escapes; the liquid that remains is the water you would drink. A pesticide does not necessarily leave with the vapor or break down just because the water is hot.
Pesticides are a broad group of chemicals, and their behavior varies. Some may change with heat or move into vapor under particular conditions, while others may remain in the water. A change in a chemical does not by itself show that the water is safe, because the original pesticide or its breakdown products may still be present.
Boiling is also not the same as distillation. Distillation collects and cools vapor back into liquid, while ordinary boiling leaves you with the water in the pot. Even with distillation, a system's ability to reduce a particular pesticide needs to be checked: some chemicals can carry over with the vapor.
What percentage of pesticides does boiling remove?
There is no dependable percentage to give for boiling pesticides out of drinking water. The result can vary with the pesticide, the boiling conditions and the amount of water that evaporates. Without measurements, neither the starting concentration nor the concentration after boiling is known.
A laboratory can report a pesticide concentration in units such as milligrams per liter (mg/L). If both the starting and final concentrations are measured using comparable samples, the percentage change in concentration can be calculated as:
(Starting concentration − final concentration) ÷ starting concentration × 100%
That calculation describes the tested sample, not a general removal rate for boiling. If the final concentration is higher because water evaporated, the calculation indicates an increase rather than removal. A lower measured concentration alone also does not establish that the water meets a relevant drinking-water standard or is safe to drink.
What should you use instead of boiling?
Start by identifying the pesticide, if possible. Contact your water utility or local health department about a known or suspected source, and ask a drinking-water laboratory which tests are appropriate. If you use a private well, your local health department may be able to help you find a suitable laboratory and sampling instructions.
Choose treatment based on the specific test result, not on a general claim that a product removes pesticides. Options include:
| Treatment | What to check |
|---|---|
| Activated carbon | It can reduce some pesticides, but effectiveness depends on the chemical and the filter. Check the certified claims for the pesticide of concern. |
| Reverse osmosis | Some systems can reduce certain pesticides. Check the system's certification and performance information for the specific chemical. |
| Distillation | A distiller collects condensed vapor, unlike ordinary boiling. Check whether the system is certified for the pesticide, since some chemicals may carry over. |
Look for independent certification to a relevant drinking-water treatment standard, such as NSF/ANSI 53 or NSF/ANSI 58, and confirm that the specific pesticide is listed in the product's certified claims. Certification for one contaminant does not mean the device reduces every pesticide. Follow the manufacturer's installation and filter-replacement instructions; an exhausted or incorrectly installed system may not perform as intended.
Ask the laboratory or health department whether to test the treated water and when to retest. Testing the source and the treated tap water can help determine whether a system is reducing the pesticide under your conditions.
If a spill or other contamination is suspected, ask your water utility or local health department whether to stop using the water. Until you have guidance, use a known safe supply for drinking, cooking and preparing infant formula. A filter is not a substitute for following an official do-not-use notice. If someone may have been exposed and feels unwell, contact a clinician or poison control; seek urgent care for severe symptoms such as trouble breathing or loss of consciousness.
Frequently asked questions
Does letting boiled water cool remove pesticides?
No. Cooling water after ordinary boiling does not reliably remove pesticides that remain in it.
Can you tell whether water contains pesticides by its taste or smell?
Not reliably. Water can contain pesticides without an obvious taste or smell, so an appropriate laboratory test is needed to check.
Can pesticides reach a private well?
Yes. Pesticides can reach groundwater through processes such as runoff or seepage. A local health department can advise which tests may be appropriate for your area.